1978 MGB Vehicle Emission Control Information Decal

You will receive: 

• (1) MGB Vehicle Emission Control Decal Replica

Decal Reads:

VEHICLE EMISSION CONTROL INFORMATION
LEYLAND CARS
BRITISH LEYLAND UK LTD.
ENGINE B/50 SERIES - 110 cu. EVAP FAMILY [CAN] LOW ALTITUDE

EXHAUST EMISSION CONTROL TYPE A.I./EGR/CATALYST CARBURETTOR SETTING PROCEDURE
RUN ENGINE UNTIL NORMAL TEMPERATURE ACHIEVED. DRIVE FOR 5 MINUTES. DISCONNECT FLOAT CHAMBER VENT (3) AND AIR MANIFORLD HOSE. BLOCK AIR MANIFOLD. SET IDLE SPEED (1) CHECK ADJUST IDLE MIXTURE SCREW (2) REFIT AIR INJECTION. RESET IDLE SPEED (1) REFIT FLOAT CHAMBER VENT PIPE (3). NOTE: RUN ENGINE AT 2500 rpm FOR 30 seconds BEFORE EACH ADJUSTMENT TRANSMISSION TO BE IN NEUTRAL, AIR CONDITIONER (IF FITTED) TO BE DISCONNECTED.

SEE WORKSHOP MANUAL FOR ADDITIONAL INFORMATION

IGNITION TIMING 10° B.T.D.C at 1500 rpm

IDLE SPEED 850 ± 100 RPM
IDLE CO SETTING 5½ ±.1%
SPARK PLUG GAP .035"
TAPPET CLEARANCE .013" WARM

THIS VEHICLE CONFORMS TO U.S. E.P.A. REGULATIONS APPLICABLE TO 1978 MODEL YEAR NEW MOTOR VEHICLES

PART No. CAM 3299