1930 Evinrude Clear Instructions Decal

You will receive:

• (1) Evinrude Instructions Decal.

Decal Reads:

FOOD - LIGHT - SLOW - START - FAST
HOW TO START MOTOR
1. Open gasoline cock under tank by turning handle down
2. Open vent screw on filler cap on top of tank to the LEFT until wide open.
3. Close needle valve on carburetor, then OPEN ¼ to 1 ¼ turns.
4. Set carburetor control lever (below tank) at "CHOKE" position.
5. Set spark control lever at "START" (see top of tank).
6. Coil starting rope clockwise and pull quickly.
7. When motor starts, move carburetor control lever needle towards "FAST" position. Move spark control lever towards "FAST" position. Close needle valve slowly until motor runs smooth and obtain desired speed by moving the carburetor and spark control levers between "FAST" and "SLOW" positions.
8. To STOP, push button at end of steering handle.
LUBRICATION
Use a good grade of gasoline. High test gives no advantage.
1. For the first ten hours mix 1 pint of Gargoyle Mobil "A" or any other high grade oil or similar body and quality in a clean, separate can with each gallon of gasoline.
2. Mix oil and gasoline thoroughly before pouring into tank.
3. After ten hours of operation, the oil can be reduced to ¼ pint the gallon of gasoline.
4. Fill the gear housing with a good grade of Outboard Motor or Grease AT LEAST ONCE EACH MONTH, or, if motor is been used constantly fill the housing every week. Lubrication is the most important factor in the operation of normal combustion engines, correct lubrication insures long and right factory performance. SEE INSTRUCTION BOOK.
OUTBOARD MOTORS CORPORATION, MILWAUKEE, WISCONSIN